So I was playing with my Cricut and everything was fine, I cut the first two pages of a project, then on the third - same paper, same settings, it wouldn't cut all the way through the paper. I double checked the settings and tried again. Same thing. It scores the paper to look like it's cut, but it isn't cutting quite all the way through. So I decided to go to another project, same brand/type of paper, and I set the multicut to 3 instead of 2. Still not cutting through, this is the Bazill cardstock so it's not horribly thick and I've done this many times before without a problem. Multicut on x2 should have been plenty. My speed is fine, pressure is max, and blade setting is 6 as suggested by the manual. I haven't had this problem before. Any suggestions? It's a new mat, new blade, seriously new out of the package and used for the first time today. I'm just very frustrated at this point.