My sister in law and I are decorateing my new nephews room and we want to do a tree that is about 5 feet tall, I'm really new with my cricut so my question is: how do we print the tree? I'm assuming we would have to peice it together right (like the trunk). Or do we need to buy a really ling peice of vinyl? Hope this makes sense
Posted on CafeMom Mobile
Posted by
on Jun. 28, 2012 at 9:46 PM
Add your quick reply below:
You must be a member to reply to this post.
Replies:
1-2 of 2 replies
by
Member
on Jun. 30, 2012 at 7:39 PM
What size is your vinyl? I would make trapezoids (I think that's what they are) and have each one get 1/2in smaller at the top. Use as much length as you can so it is taller. Maybe mix them with rectangles too. Then branches and leaves separate.
Posted on CafeMom Mobile
by
New Member
on Jul. 22, 2012 at 8:45 PM
I agree with PP. I think you will have to piece it together, but with vinyl if you line it up very well it is very hard to see the seems.
1-2 of 2 replies
Add your quick reply below:
You must be a member to reply to this post.
I was gone for a while
- lucki_flip05
on Jun. 28, 2012 at 9:46 PM